For that distance I would run AWG # 3 copper and install a sub-panel.
Depends on the size of the sub-panel in that garage. If you are installing a 60 amp sub-panel 400 feet away from the main service panel then use AWG # 4.
Re Question with the voltage that you will be using.
Yes you do. The detached garage will either be fed with a single circuit or a sub panel. The wire feeding the garage will need to be protected and that is the purpose of the breaker (disconnect). The breaker size will be determined by the size of the wire that is used on this circuit.
I would install a 60 amp sub-panel and use AWG #3 copper.
For a 60 amp sub panel located 100 feet away, it is recommended to use a 6-gauge wire size to ensure proper electrical conductivity and safety.
For that distance I would run AWG # 3 copper and install a sub-panel.
Depends on the size of the sub-panel in that garage. If you are installing a 60 amp sub-panel 400 feet away from the main service panel then use AWG # 4.
Re Question with the voltage that you will be using.
You need the stand size window opening of 2.5 feet by 2 feet.
For a 100 amp main panel located 100 feet away, it is recommended to use a 2/0 copper or 4/0 aluminum service cable to ensure proper voltage drop and capacity for the distance. Consult with a licensed electrician to determine the specific requirements based on local codes and conditions.
For a 125 amp sub panel located less than 200 feet away from a 200 amp panel, you would typically use a 2 AWG copper wire or 1/0 AWG aluminum wire to safely carry the current load. It's important to follow local electrical codes and regulations when selecting the wire size.
To install a garage sub panel, you need to first determine the appropriate size and location for the panel. Then, you will need to run a conduit from the main panel to the garage, install the sub panel, connect the wires, and properly ground the panel. Finally, you will need to test the panel to ensure it is functioning correctly and safely.
it depends on what size your feet are
The size of a standard solar panel typically ranges from 15 to 20 square feet. This size can vary depending on the specific brand and model of the solar panel.
40 feet
A 3/0 copper conductor with an insulation rating of 75 or 90 degrees C is rated at 200 and 210 amps respectively. A 3/0 copper conductor will limit the voltage drop to 2% or less when supplying 200 amps for 80 feet on a 240 volt system.