0
To draw a decagon using a compass, start by drawing a circle with the compass. Mark the center of the circle and label it as point O. Then, divide the circle into ten equal arcs by first finding the radius and using a protractor to measure 36-degree angles (360°/10). Finally, use the compass to mark each point around the circle, and connect these points to form the decagon.
What else can I help you with?
How do you draw a regular decagon using a compass?
To draw a regular decagon using a compass, start by drawing a circle with your compass. Next, mark a point on the circle to serve as one vertex of the decagon. Then, use the compass to construct the radius and divide the circle into ten equal segments by marking points at equal angles (36 degrees apart). Finally, connect these points with straight lines to form the decagon.
How do you draw a hexagon shape without using a compass?
you just draw lines
How do you draw a decagon?
A decagon is a shape that has ten sides. As long as the figure has ten sides to it, then it is a decagon.
How do you draw a circle in assembly program?
You can draw a circle in assembly program by using a compass-like tool. Secure the tip of the compass and then rotate the compass tool so that it completes the circle.
How can you draw a decagon?
draw a shape with ten sides
How do you draw a regular decagon using a compass?
To draw a regular decagon using a compass, start by drawing a circle with your compass. Next, mark a point on the circle to serve as one vertex of the decagon. Then, use the compass to construct the radius and divide the circle into ten equal segments by marking points at equal angles (36 degrees apart). Finally, connect these points with straight lines to form the decagon.
How do you draw a rhombus using a compass?
first you draw a circle, divide it into 4
How do you draw a hexagon shape without using a compass?
you just draw lines
How do you draw a decagon?
A decagon is a shape that has ten sides. As long as the figure has ten sides to it, then it is a decagon.
How do you draw a circle in assembly program?
You can draw a circle in assembly program by using a compass-like tool. Secure the tip of the compass and then rotate the compass tool so that it completes the circle.
How can you draw a decagon?
draw a shape with ten sides
How do you draw 75 degree angle using ruler and compass only?
first draw a ray .
How do you draw a whole angle?
measuring using a compass n protector
How do you draw a decagon with MSWLogo?
A decagon is a 10-sided polygon. To draw a regular decagon in MSWLogo, first create the following procedure: to decagon :n repeat 10 [fd :n rt 36] end Now invoke it: decagon 100 This creates a decagon with sides of length 100.
One can draw a geometric figure using?
Geometric figures can be drawn using a compass and a straight edge. This is commonly known as ruler and compass construction.
How do you draw a trapezium by using ruler compass protector and setsquares?
Check on youtube!
How can you draw an arc on your computer like you are using a compass?
use an arc tool
