The volume of the pool is (40m x 25m x 2m) = 2,000 m2 = 2,000,000 liters
See how nice it can be to work with metric units ? !
Two days. Fill for one day. If not completely full, Continue on second day.
8x2x1=16
1795 gallons, if you fill it to the brim.
598 Imperial gallons, approx.
To determine water pressure using the time it takes to fill a two-gallon bucket, you first measure the time it takes for the bucket to fill completely. Then, you can calculate the flow rate by dividing the volume of the bucket (two gallons) by the time taken (in minutes or seconds). A faster fill time indicates higher water pressure, while a slower fill time suggests lower pressure. This method provides a practical, though indirect, assessment of water pressure in a plumbing system.
The time it takes for a hot water heater to fill up completely can vary depending on the size of the tank and the water pressure. On average, it can take anywhere from 30 minutes to an hour for a hot water heater to fill up completely.
Two days. Fill for one day. If not completely full, Continue on second day.
depends on water pressure, but it should completely fill in 15-20 minutes. the water should be hot in another 20-25 minutes if it has been run completely empty.
It depends... how long, wide, and deep it is.
8x2x1=16
about 5 min. if it's only 1" deep, depending on water pressure.
509.7 litres
1795 gallons, if you fill it to the brim.
The time it takes for a toilet to fill up completely can vary, but on average it usually takes about 2-3 minutes.
598 Imperial gallons, approx.
I think there is 2
It would take 2500 m^3 (2500 cubic meters) of water. This is equal to 2,500,000 liters or about 660,430 US gallons.