lap length is the inside dimension of a pool whereas the Development length is the dimension of the hole required to build the pool.
A lap is not a standard unit of length and so the question cannot be answered. For example, a lap ina swimming pool will be quite different to one on a track field.A lap is not a standard unit of length and so the question cannot be answered. For example, a lap ina swimming pool will be quite different to one on a track field.A lap is not a standard unit of length and so the question cannot be answered. For example, a lap ina swimming pool will be quite different to one on a track field.A lap is not a standard unit of length and so the question cannot be answered. For example, a lap ina swimming pool will be quite different to one on a track field.
no a lap is down and back
The answer depends on the length of a lap: a lap of a running track will be considerably larger than a lap of a swimming pool!
0.25l, 0.3l
lap length is the inside dimension of a pool whereas the Development length is the dimension of the hole required to build the pool.
A lap is not a standard unit of length and so the question cannot be answered. For example, a lap ina swimming pool will be quite different to one on a track field.A lap is not a standard unit of length and so the question cannot be answered. For example, a lap ina swimming pool will be quite different to one on a track field.A lap is not a standard unit of length and so the question cannot be answered. For example, a lap ina swimming pool will be quite different to one on a track field.A lap is not a standard unit of length and so the question cannot be answered. For example, a lap ina swimming pool will be quite different to one on a track field.
The lap length for welding a reinforced bar will depend on the size of the bar that is being welded. If the bars are different diameters when lapped, the lap length should be calculated using the lesser diameter.
lap length in tension including anchorage value of hooks in flexural tension shall be greater of development length or 30 times dia of bar. In compression, its equal to development length. In general, 50 times dia is provided.
Many people have different views on this. Most refer to a lap as one length of the pool. Others say is it down AND back.
The length of a lap in a footrace is 400 meters. I should know I run it.
The difference between the two is in the application. A development length is the amount of rebar length that is needed to be embedded or projected into concrete to create a desired bond strength between the two materials. The lap splice length is the length two rebar pieces must overlap and be tied together to create a bond as if there was no break and the run is "continuous". So simply put, development is rebar to concrete, splice is rebar to rebar. The lengths of both splice and development do vary. They are dependent upon different factors. These include but are not limited to concrete strength, rebar size, rebar coating and concrete cover or clearance. So when you see a chart on one project, it can differ from another for these reasons.
no a lap is down and back
Lap length is the length overlap of bars tied to extend the reinforcement length.. Lap length about 50 times the diameter of the bar is considered safe. Laps of neighboring bar lengths should be staggered and should not be provided at one level/line. At one cross section, a maximum of 50% bars should be lapped.In case, required lap length is not available at junction because of space and other constraints, bars can be joined with couplers or welded (with correct choice of method of welding).
People have different views. Most people say it is one length. Others say it is down and back.
not sure but i think that they continud the lap over and the first one to finish would win
The answer depends on the length of a lap: a lap of a running track will be considerably larger than a lap of a swimming pool!