total cost ÷ square footage
36
A square foot cannot be expressed in length alone but must be expressed in area. That is a square foot is a square of which both the length and width equal one foot or 0.3048 meters.
This varies depending on location, size & type of job (wall? ceiling?) so get several estimates.
the answer is 13,825 gallons... I just had one installed and this info is in the liner fact sheet. hope this helps.
No
By now I'm sure you've found the answer. But a Pontiac engine does not have adjustable valves. You simply torque them down to 20 foot pounds.
From the factory, Pontiac engines do not have adjustable valves. You simple torque them down to 20-25 foot pounds.
total cost ÷ square footage
Foot. In order to make a legal shot and not foul, one foot must remain on the floor. There is no limit to how much of the foot, but some portion of the player's foot must be on the floor when a shot is made or it is a foul.
Most single foot valves have one input port and one output Most double have two or more of each and are actually two separate valves in one body so if one fails the other will continue to work.
A whistle or horn must be aboar a 22 foot powerboat
1
This will depend where in the world you are. Expect to pay $1.50 to $2.50 per square foot for basic installation.
That takes 80 foot-pounds, equivalent to about 59 joules.
The foot valve in a well should be the same size as the down pipe, usually 1 inch, but could be as small as 3/4 or as large as 1 1/2 . Foot valves are made in all those sizes.
Well If you can find someone who'd sell it cheap, probably 25$-50$ per square foot.