The decimal point moves 3 places to the right.
Multiply the quotient by the divisor to result in the dividend.If dividend/divisor=quotient, then dividend=quotient x divisor
Divide as normal, but make sure to place the decimal point in the quotient directly above the decimal point in the dividend.
3.8
Since the calculation entails division by 105, the decimal point (implied at the right of 6000) should be moved 5 places to the left.
A quotient. A decimal is simply one of many ways of representing a number.
Multiply the quotient by the divisor to result in the dividend.If dividend/divisor=quotient, then dividend=quotient x divisor
Divide as normal, but make sure to place the decimal point in the quotient directly above the decimal point in the dividend.
Put the decimal point for the quotient exactly above the decimal point in the dividend. Then forget about it, and just keep your digits lined up as you do the division. The decimal point winds up exactly where it belongs in the quotient.
No.
If it's long division then it is because the quotient will become a decimal number after its decimal point
0.125
The quotient can be smaller or larger - depending on whether the original was negative or positive. It will be unchanged if it was 0.
It is called a divisor. The inside number is called the dividend and the answer is the quotient. The leftover number is called the quotient but you can keep dividing until you get a decimal.
The decimal point goes in the quotient the moment you reach the decimal point in the dividend and need to use the digit in the tenths column. When using the "Bus stop" method, the digits will line up so that the decimal point goes in the quotient directly above the decimal point in the dividend.Using the Bus stop method, it is easiest to put the decimal point in the quotient above the decimal point in the dividend first (before any any division calculation is done) and then do the division by ignoring the decimal points and putting digits in the quotient as normal; except if once all the digits of the dividend have been used there is a non-zero remainder, zeros can be added to the end of the dividend as they are trailing zeros after a decimal point which make no difference to the number.eg dividing 1.2 by 5:First place the decimal point in the quotient over the decimal point in the dividend:_____.___------5_|_1.2Now divide as normal:____0.2__------5_|_1.2____1 0____----______2Used up all the digits of the dividend but have a remainder, so add trailing zeros after the decimal point and finish the division:____0.24__--------5_|_1.2000____1 0____----______20______20______---_______0Only needed one extra 0, but it did not hurt putting three of them.→ 1.2 ÷ 5 = 0.24Sometimes the decimal may recur or not terminate; in that case, stop when the required level of accuracy is reached (rounding by calculating a further digit and using that as the deciding digit).
3.8
Since the calculation entails division by 105, the decimal point (implied at the right of 6000) should be moved 5 places to the left.
A quotient is the result of dividing one number by another. It can be expressed as a ratio or as a decimal.