0.15 inches on a ruler is slightly more than 1/8 inch but less than 1/4 inch. Most standard rulers have markings for 1/16 inch increments, so you can estimate 0.15 inches as being just a bit past the 1/8 inch mark (which is 0.125 inches). It can be helpful to use a ruler with finer markings for more precise measurements.
The thickness of .015 is 0.015 inches. This is equivalent to 15 thousandths of an inch.
0.015 = 15/1000 = 3/200 So 0.015 of an inch equals 15 thousandths of an inch.
Five eighths of an inch on a ruler would be located between the half-inch mark and the three-quarter inch mark.
where is .39 on a ruler
get a ruler
The thickness of .015 is 0.015 inches. This is equivalent to 15 thousandths of an inch.
inch ruler
0.015 = 15/1000 = 3/200 So 0.015 of an inch equals 15 thousandths of an inch.
an inch ruler is 2.5cm and a cm is the same but smaller.....saichona
Breaker Gap, Inch: .015
A mil is 1/1000 of an inch or .001. 15 mils is .015"
The answer depends on the measurement units used for 8.3
That depends on the ruler. If you refer to a 1 foot ruler, divided in inches and sub-inch divisions, then 0.39 inch is a more than a quarter inch, and less than a half inch.
Five eighths of an inch on a ruler would be located between the half-inch mark and the three-quarter inch mark.
where is .39 on a ruler
with a ruler
It depends on your ruler and what units are on your ruler. To measure to the nearest inch just find the inch measurement and round up or down to get to the nearest inch in your measurement is between two whole numbers.