0
a spring clip is somthing on a microspope to hold down a slide on the microscope
Add your answer:
Earn +20 pts
What is the purpose of a carabiner clip?
A carabiner clip is a metal loop with a spring loaded gate. The purpose of a carabiner clip is to remove slack from a rope or cord. It is often used in climbing.
How does the paper clip work?
you clip stuff together.
What does a magnent do to a paper clip?
The paper clip clings to the the magnet
1 property of a paper clip?
There are only one property of a paper clip. The property to a paper clip is the testing.
What does a paper clip and pencil have in common?
What does papar clip, pen and penicl have in common
How do you replace the spring clip on the headlight?
You have Hyundai redesign the dang thing. What a hassle this spring clip is. A picture would be great cause when I got my big hands in there the clip went flying.
What is a spring clip removal tool?
It is a tool designed to remove spring clips.
What is a microscope clip?
a spring clip is somthing on a microspope to hold down a slide on the microscope
What is a spring clips microscope?
a spring clip is somthing on a microspope to hold down a slide on the microscope
How do you remove the elantra headlight spring clip?
Push spring clip forward and while pushing turn it towards the right. It should fall away to allow you to remove the bulb.
How do i Remove GM fuel injector electrical connectors?
There is a spring clip that holds them on. Squeeze the clip and then pull the electrical connector off.
How is a hulka clip used in tubal ligation?
The surgeon places a plastic clip across a tube held in place by a steel spring.
What is the purpose of a carabiner clip?
A carabiner clip is a metal loop with a spring loaded gate. The purpose of a carabiner clip is to remove slack from a rope or cord. It is often used in climbing.
What holds the clip in a 22 rifle?
Usually a spring holds the MAGAZINE in place. I don't know of any .22 rilfe that uses a clip.
How do you remove the wind up window handle on 03 fiesta?
The winder fits onto a splined shaft, with a groove cut into it near the end. The winder handle has a spring clip, like an external circlip, which protrudes into the door card. The handle is simply pushed onto the shaft until the spring clip drops into the groove. To get it off, you need to find a way of pushing the spring clip off the winder handle. Try depressing the door card around the winder and look in to see if you can push the spring clip off, from around the handle shaft, using a screwdriver.
What is a mohr clip?
A Mohr clip is a spring-loaded tubing clamp that pinches off the flow of liquid through plastic tubing. You have to squeeze the thumb clips together to open the flow, or to remove the clip.
How does one install recoil spring in a ted Williams model 3t 22 cal rifle?
Drill a small hole at the end of the recoils plug that goes in the spring. compress As much spring as posible and slide a paper clip in hole you drilled which will keep spring compressed. Slide spring into hole and push recoil plug as far into hole as possible before pulling paper clip. Slide rest of spring in now and drop bolt in before releasing spring.
