No, there is a tandem single pole 3030 but GE does not make a tandem two pole 3030.
No tandem breakers are of the same value.
No, each segment of a tandem breaker is what the breaker rating on the handle states. Tandem breakers are used when there is no space left in the distribution panelboard. You get an extra circuit by removing the full size breaker and installing a tandem breaker,
No, a double pole 50 amp breaker protects a 240 volt supply at 50 amps. The number that is on the handle of the breaker is the amperage that the breaker will trip at if an overload occurs on the circuit.
Remove the 30 amp double pole breaker and install at least one single pole 15 amp breaker. It is best if the other slot is not left open so if you have another single pole breaker of any size install it in the 2nd spot so it isn't open when you replace the cover on the panel. For your 15 amp circuit you need #14 gauge copper wire or larger with a hot, neutral, and ground. Your 30 amp circuit was probably wired with #10 gauge conductors. These will probably work on your 15 amp circuit but it may be difficult to connect #10 conductors to devices.
Yes, a 2 pole 60 amp ITE Gould or Westinghouse breaker can replace a 2 pole 60 amp T and B unit as long as they have the same voltage rating and fit properly in the panel. It is important to make sure that the replacement breaker is compatible with your specific panel model.
A tandem 20 amp breaker is designed to provide two separate circuits in one breaker slot, allowing for more circuits in a limited space. It is different from a standard single-pole breaker, which only provides one circuit per slot.
No tandem breakers are of the same value.
A 15 amp tandem breaker can handle a maximum electrical load of 15 amps.
No, each segment of a tandem breaker is what the breaker rating on the handle states. Tandem breakers are used when there is no space left in the distribution panelboard. You get an extra circuit by removing the full size breaker and installing a tandem breaker,
The appropriate double pole 30 amp breaker to use for a dryer installation is a 30 amp double pole circuit breaker.
No, a double pole 50 amp breaker protects a 240 volt supply at 50 amps. The number that is on the handle of the breaker is the amperage that the breaker will trip at if an overload occurs on the circuit.
Remove the 30 amp double pole breaker and install at least one single pole 15 amp breaker. It is best if the other slot is not left open so if you have another single pole breaker of any size install it in the 2nd spot so it isn't open when you replace the cover on the panel. For your 15 amp circuit you need #14 gauge copper wire or larger with a hot, neutral, and ground. Your 30 amp circuit was probably wired with #10 gauge conductors. These will probably work on your 15 amp circuit but it may be difficult to connect #10 conductors to devices.
You have a double pole breaker for 240Volt supply. The maximum current is 15 amp.
The maximum current rating of a 2 pole 60 amp breaker is 60 amps.
The maximum current rating of a 2 pole 25 amp breaker is 25 amps.
Yes, a 2 pole 60 amp ITE Gould or Westinghouse breaker can replace a 2 pole 60 amp T and B unit as long as they have the same voltage rating and fit properly in the panel. It is important to make sure that the replacement breaker is compatible with your specific panel model.
AWG 12/2 requires the use of a 20 amp single pole breaker.