Each computer will have an amperage rating. Using 80% rule for continuous load you should not exceed 16 Amps total. You'll have to add in your monitor power as well. Your start up current can be slightly higher due to bringing discs up to speed.
A typical desktop might draw from 2 to 3 amps. Depending on type a monitor may draw from 1 to 3 amps.
A typical laptop may draw 1.5 amps from charger.
To hook up a 40 amp breaker panel, first turn off the main power source. Then, connect the wires from the circuit breaker to the panel's bus bar, making sure to follow the manufacturer's instructions. Lastly, turn the main power back on and test the circuit to ensure it is working properly.
A 15 amp breaker is not sufficient for a 225 amp load. You would need a breaker that matches the load current, such as a 225 amp breaker. Using a 15 amp breaker for a 225 amp load would cause the breaker to trip immediately due to overcurrent.
It's the amps that are controlled by the breaker not the volts. You can have a 600 volt 15 amp breaker, you can have a 347 volt 15 amp breaker. The breaker will trip when you exceed 15 AMPS.
No tandem breakers are of the same value.
No, a breaker needs to be loaded less than 80 percent. As they reach their tripping point they get hot. The circuit rating, breaker and wiring is not designed for 21 amps. The next size would be a 25 to 30 amp breaker that has #10 wire feeding it.
To hook up a 40 amp breaker panel, first turn off the main power source. Then, connect the wires from the circuit breaker to the panel's bus bar, making sure to follow the manufacturer's instructions. Lastly, turn the main power back on and test the circuit to ensure it is working properly.
A 32 amp fixture can not be fed from a 20 amp breaker as the breaker will trip every time.
A 15 amp breaker is not sufficient for a 225 amp load. You would need a breaker that matches the load current, such as a 225 amp breaker. Using a 15 amp breaker for a 225 amp load would cause the breaker to trip immediately due to overcurrent.
Replace the 30 Amp Breaker with a 15 Amp breaker.
It's the amps that are controlled by the breaker not the volts. You can have a 600 volt 15 amp breaker, you can have a 347 volt 15 amp breaker. The breaker will trip when you exceed 15 AMPS.
A 50 amp breaker is an overcurent device.
No, you should not replace a 15 amp breaker with a 20 amp breaker without consulting a licensed electrician. The breaker size should match the wire size to prevent overheating and potential fire hazards.
You have a double pole breaker for 240Volt supply. The maximum current is 15 amp.
NO!
Yes, a 30 amp breaker is a 30 amp breaker. It must however be able to fit the box it is installed in.
No more than 13 maximum on a 20 amp circuit.
No, it is not safe to use a 15 amp outlet on a 20 amp breaker as it can lead to overheating and potential fire hazards. It is important to match the outlet's amp rating with the breaker's amp rating for safety.