it is hardware not software
No; electron-volt is a measure of energy, not of voltage (or potential).
2 amperes (current = voltage/resistance)
RMS is a type of average. It is the "root of the mean of the squares". That is, the individual values are squared, the average is taken, and the square root of this is calculated. Since the "individual values" are often continuous - a typical example is a voltage, which continuously changes for example as a sine wave - integration must be used.
Capacitors resist change in voltage, so initially it will want to keep it's voltage (across it) the same. Depending on the configuration, the cap could initially behave as a short to attempt maintain that condition, or as a voltage source (if voltage was already present across the cap, for instance).
-10
100v divided by 1.41
When a technician uses a voltmeter he or she can measure the power going through a circuit. It can test the safety and reliability of a an appliance also.Another AnswerA voltmeter is used to measure the potential difference, or voltage, between conductors. To measure power (as mentioned in the original answer) you need a wattmeter, not a voltmeter.
a voltmeter is used to measure voltage
There are different units for electricity, depending on what you want to measure; for example: volts to measure voltage amperes to measure current watts to measure power etc.
Any one using a voltage test instrument can measure charge differential voltage.
Many can measure both - Vrms (AC) or DC voltage.
The unit of measure for voltage is volt. Ohm measures resistance.
You measure the peak to peak voltage and divide by 2.
With the system powered on and playing sounds measure the voltage at the speaker terminals with an AC voltmeter. If you measure voltage turn off the system and disconnect one of the speaker terminals and measure across the speaker with an ohm meter. If there is any significant conductance the wire is probably carrying current when the system is playing. Better yet take it to a competent technician.
A voltmeter would measure the voltage. If you measure the voltage drop over a known low resistance you get a kinda-sorta idea of the power available.
You don't. You need test equipment to measure voltage.
A voltmeter measures voltage in volts.