0
What else can I help you with?
Do multiply or divide convert kohms to ohms?
Ohms are smaller than k-ohms, so number of ohms must be a bigger number. Multiply k-ohms by 1,000 to get the same resistance in ohms.
Resistance is measured in a unit called?
ohms
What is the Mathematical formula for OHMS law?
Current = voltage/resistance
What is 30 percent of 1100 dollars?
To find 30 percent of any value, multiply the value by 0.3. Like this, 0.3 x 1100 = 330. Therefore, 30 percent of $1,100 is $330So the answer is $330.
What is the value of 1100 pieces of silver?
The value of 1100 pieces of silver can vary significantly based on the current market price of silver, which fluctuates regularly. As of recent market trends, silver is typically valued around $25 to $30 per ounce. If we assume each piece of silver weighs one ounce, then 1100 pieces would be worth approximately $27,500 to $33,000. However, if the pieces are historical or collectible, their value could be much higher.
What is the power if current is 1.17A and resistance 1.1k Ohms and Round result to whole number?
Power = 1 A and resistance = 1100 Ohms.
What OHMS stand for?
That is the value of a resistance.
What is the value of the resistance of an short circuit?
ohms
The value of the resistors orange orange orange silver?
1100 ohms, +/-5%
What is the idle value of human body resistance?
0.4 ohms
What is the acceptable value of contact resistance?
30 micro ohms
What will be earth resistance value of power grid?
Below 5 ohms
What are resistor values defined by?
Resistor value is defined by the Resistance the resistor offers in Kilo ohms/ohms value given by color codes on the resistor.
What is the resistance value on the back of the fuel gauge for a 1981 corvette?
It is 90 ohms
What is the resistance of a 1100 W 120V hair dryer?
The resistance of the hair dryer can be calculated using Ohm's Law, which states resistance (R) equals voltage (V) squared divided by power (P). Plugging in the values, the resistance of the hair dryer is approximately 13.09 ohms.
What is the acceptable value of grounding resistance for any application?
An acceptable resistance for a ground to ground plate system is 2 ohms with a maximum allowance to 5 ohms. If the measured resistance is above 5 ohms more grounding rods or plates have to be added to reduce the resistance down to the acceptable levels.
What is the resistance of the circuit in ohms?
The resistance of the circuit is measured in ohms.
