The values of tan are limitless (that is to say, within [-inf, inf]). However, sin and cos ratios are between -1 and 1. Think about it: sin = opposite/hypotenuse. Since hypotenuse is always larger than or equal to opposite, sin must always be less than 1. Same with cos.
Since the hypotenuse (denominator) is always greater than the opposite or adjacent side (numerator), the ratio will always be smaller than one.
it is due to the fact that the length of an inclined plane(effect arm) is greater than its vertical height(load arm).
It too will have a value of 5
negative one half
One maggot will produce one fly! that fly will then produce hundreds of maggots, and so on....There will ALWAYS be flies!!
The - before the 1 represents it is less, so the -1 will always be less than a, since the - is before the one, and so that means the 1 is less than a.
Pretend that a stands for the number of apples you have. If you take one apple away from the number of apples you have, you will always end up with one less apple.
0.441 of something is always less than a whole one. In fact, it's always 55.9 percent less than a whole one.
The sine and the cosine are always less than one.
That is true.
When adding two fractions that are both less than one half, the sum will always be less than one. Specifically, if both fractions are positive, their sum will be less than one because the maximum possible value for the sum is one half plus one half, which equals one. Therefore, the sum of two fractions each less than one half will be less than one.
... less than the original fraction.
If you look at the definition of the sine function in a triangle, you'll discover that the maximum possible value of the sine function is ' 1 ' and the minimum possible value is ' -1 '. There's no angle that can have a sine greater than ' 1 ' or less than ' -1 '. So the absolute value of the sine of anything is always ' 1 ' or less.
1/2 is less than one.
Any fraction where the numerator is less than the denominator your value is less than one.
The Rf value, or retention factor, is a measure of how far a compound travels on a chromatography medium relative to the solvent front. It is always less than one because the Rf value is calculated by dividing the distance traveled by the compound by the distance traveled by the solvent front; since the compound cannot travel further than the solvent, the ratio remains less than one. This characteristic helps in identifying and comparing compounds based on their movement during chromatography.
A Mersenne number is one less than a positive power of two. Since the positive power of two is always even, one less than that is always odd.