It depends on the application, but for Single-Phase dwelling service and feeders
3 AWG copper is good for 110 amps. That really equates to 100 amps since you can't get a 110 amp circuit breaker.
Impossible to answer without knowing the voltage and length of wire you intend to run.
AWG 10.
10 amps
6 AWG.
It will taken 8 amps <<>> The conversion of 2.5 sq mm wire to AWG is equal to a #12 wire. The ampacity of a #12 copper wire with an insulation factor of 90 degrees C is 20 amps.
6 AWG will handle 50 amps with a voltage drop of about 4 volts. If you go to 4 AWG and limit to 50 amps your voltage drop will be 2.5 volts.
Yes, 12 AWG is good for 25 Amps if copper wire.If aluminum wire, then good for 20 Amps.
AWG 10.
14 AWG of 105 degree Celsius copper wire is rated for twenty-five amps.
Copper wire current ratings assume 10 amps per mm2 for currents up to a few amps. 26 AWG wire has a cross sectional area of 0.13 mm2 so this logic says 1.3 amps.
Look on the heater and see what amps it is pulling. That will determine the wire size and breaker size. It must be on a dedicated circuit. 15 amps = AWG # 14 wire with 15 amp breaker 20 amps = AWG # 12 wire with 20 amp breaker 30 amps = AWG # 10 wire with 30 amp breaker 40 amps = AWG # 8 wire with 40 amp breaker
Yes you can. You did not say how many amps were required.
The normal current capacity of 12 AWG copper wire is 20 amps.
10 amps
Service wire for 100 amps requires AWG #3 copper.
8 AWG.
6 AWG.
Service wire required is AWG # 3/0 copper.