Want this question answered?
No, the bare copper grounding conductor can not be in a conduit with other conductors. It can be in conduit by itself to provide mechanical protection for the wire.
The NEC allows 26.
In the US, the National Electrical Code (NEC) will allow you to install single phase and three phase systems in the same conduit.
It depends on the wiring, the current load in the wiring , and the distance. The NEC Code book has the charts for this.And the size of the conduit.
Metal conduit must be buried to at least 6 inches. Non-Metal conduit must be buried to at least 18 inches. Direct bury wire must be buried to at least 24 inches. This is what the NEC requires but your local codes may be even deeper. Check with your local utility to see what they require.
Welding is not allowed by the NEC (United States' code).
The NEC allows 26.
No, the bare copper grounding conductor can not be in a conduit with other conductors. It can be in conduit by itself to provide mechanical protection for the wire.
Three number three wires can be installed in an inch and one quarter conduit.
In the US, the National Electrical Code (NEC) will allow you to install single phase and three phase systems in the same conduit.
In Canada from grade to five feet for mechanical protection.
It depends on the wiring, the current load in the wiring , and the distance. The NEC Code book has the charts for this.And the size of the conduit.
The 2008 NEC code states that conduit must be strapped within 36" or 3 feet from every box or connector, then every 5 feet is acceptable from there.
Metal conduit must be buried to at least 6 inches. Non-Metal conduit must be buried to at least 18 inches. Direct bury wire must be buried to at least 24 inches. This is what the NEC requires but your local codes may be even deeper. Check with your local utility to see what they require.
It depends on the wiring, the current load in the wiring , and the distance. The NEC Code book has the charts for this.And the size of the conduit.
9 - Is this a test answer or do you just want to know for a project you're doing? Take a look at NEC chapter 9 - tables 4 and 5 (in the 2005 edition at least)
According to appendix C of the NEC, 3 #2 awg are permitted in a 1" EMT.