A 12 gauge wire can support a load of approximately 2200 watts.
10/3 wire with 30 amp double pole breaker from panel box to water heater.
2 AWG.
Yes it is wired with copper 2 wire is also known as 14/2 wire is use for switches,outlets,lights. and a 15a outlet should only be on a 15a breaker the main power feed to your meter to your panel is aluminum and can take more of a load than copper. In the US, 15 amp receptacles can be installed on 20 amp circuits if there is more than one receptacle on that circuit. Copper wire can carry a larger load than aluminum wire of the same size.
the size of the wire that you need to run depends on the the amperage of the device/appliance you'll be hooking up to that line. Use #12 wire for 20 amp, #10 for 30 amp, #8 wire for 40 amps and #6 for 50 amps. Hope that helps.
AWG # 8
AWG # 14
Awg #6
2.5 squre mm
AWG # 10 wire on 30 amp circuit.
A 12 gauge wire can support a load of approximately 2200 watts.
Number 2 American Wire Gauge
Electrical wire size is directly dependant on the load amperage that is connected to it. The higher the load amperage, the larger the cross sectional area of the wire needs to be. The connected amperage to a conductor is determined by a group of electrical experts and their results are then written into the latest addition of the electrical code book of the country in which you live.
The correct size fuse needed is based on the size wire used in the circuit. The size wire needed is based on the load that will be applied to the circuit. 1. AWG 14/2 wire = 15 amp fuse 2. AWG 12/2 wire = 20 amp fuse 3. AWG 10/2 wire = 30 amp fuse 4. AWG 8/2 wire = 40 amp fuse
12 AWG in most circumstances.
40 amp
No. The 20 amp breaker is probably protecting a #12 wire. Connecting a 40 amp breaker to the 20 amp #12 wire would seriously overload the #12 wire. This means that if the load increased to a full 40 amps the insulation on the smaller size wire would most likely melt off and the wire could short out.