if I have seen this right, you are converting ohms to siemens?
Check you conductivity (siemens), divide "1" by the conductivity value.
in scientific notation 1000 would be 1x10^3 and change the units to ohms.
If correct, you should have 5x10^5.
May not have helped you.
Chat with our AI personalities
Ohm's law is the basic answer. Voltage = Current * Resistance is ohms law. In order to find current divide voltage by Resistance V/R=I where I is current.
The Zero Ohms Adjusting Knob on the Multi Tester ToolThe VOM (Volt-Ohm Meter) is type of measuring equipment used for reading the three major properties of electricity which are the Voltage, Current and Resistance. This tool typically has a huge rotating knob on the middle part which allows you to select the type of electrical property that you would like to measure. At the bottom part are the two probes differentiated with Red and Black color. The Red probe denotes the positive terminal while Black for the negative terminal.Now, you might be wondering about the other smaller rotating knob just above the huge selector which is labeled as Zero Ohm. This adjusting knob only concerns about resistance. It doesn't have any effect when the primary selector is set for Voltage and Current.