This is a voltage drop question. A 300 MCM copper or a 500 MCM aluminium conductor will limit the voltage drop to 3% or less when supplying 200 amps for 450 feet on a 240 volt system. The cheapest of the two conductors would be the aluminium conductor. For direct burial is will have a ACWU 90 designation.
Depends on the size of the sub-panel in that garage. If you are installing a 60 amp sub-panel 400 feet away from the main service panel then use AWG # 4.
In conduit? direct burial? distance?
12/3 will work.
The most significant part of the equation is, what will be the maximum current draw? If it's to be a small current draw, for example 40 Amp service (40 amp breaker), you'll use 8AWG wire that's rated for direct burial. Higher current rating will require larger wire. As always, if you have any questions about the proper wiring or how to connect electrical service, contact a local electrical contractor. Understand that improper wiring can result in fire and/or death.
A 200 amp service panel with a 60 amp sub-panel.
Depends on the size of the sub-panel in that garage. If you are installing a 60 amp sub-panel 400 feet away from the main service panel then use AWG # 4.
In conduit? direct burial? distance?
12/3 will work.
For a 100 amp direct burial installation, it is recommended to use copper wire with a minimum size of 3/0 AWG (American Wire Gauge) or larger. Copper wire is preferred for its conductivity and durability in underground applications.
The service is calculated on the highest voltage. That will be 240 volts. A #1 copper or a 2/0 aluminium conductor with an insulation factor of 90 degrees C and a voltage drop of 3% over 250 feet will do the job. For direct burial try an ACSR 90 cable. It is cheaper than copper by far.
For a distance of 450 feet, you would need, 2 sets of #4/0 (parallel 6 conductors) for aluminum, or 1 set of #350 copper.80% loading of service and a 3% voltage drop.Consult your local power company for exact requirements of their codes.
its posable that 100amps direct burial cable (copper at your best) in my sugestion should be a minium size of 2/0 and ground size of #2 this is stepped up for voltage drop concerns. check your authority first prior to any work ,
The recommended specifications for installing 100 amp aluminum service wire in a residential electrical system include using wire that is at least 2 AWG in size, rated for use in wet locations, and approved for direct burial. It is important to follow local building codes and regulations when installing electrical wiring to ensure safety and compliance.
Sometimes a made to measure roller blind service is needed to get blinds just the right size. Some companies that provide this service are Made to Measure Blinds and Direct Blinds.
as it covered his mummy the answer is yes the mask is life sized. the Egyptians did this so the gods would be able to see there face as it was.
According to the King Size Direct webpage, the company was acquired by RedCats USA in 1995.
The most significant part of the equation is, what will be the maximum current draw? If it's to be a small current draw, for example 40 Amp service (40 amp breaker), you'll use 8AWG wire that's rated for direct burial. Higher current rating will require larger wire. As always, if you have any questions about the proper wiring or how to connect electrical service, contact a local electrical contractor. Understand that improper wiring can result in fire and/or death.