Yes you can depending on the wattage of the amp. i personally would only put two 12's on one amp. cause it will still bump hard!!(:
"milli" means a thousandth in the metric units of measurement. Thus 1000 milliamps = 1 amp.
Difference_between_copper_and_bronze
-- If the 3 Amp is being drawn from a battery,then the battery is supplying3 x (Voltage of the battery) watts.-- If the 3 Amp is flowing through a resistor,then the resistor is dissipating9 x (Resistance of the resistor) watts.
Their are two ways select ratio analysis & tally gives you various ratios alternatively select profit & loss account Press F12 & select show percentages as yes and save
Yes, a 1200 watt amp can provide good bass for 2 Kicker CVR 12-inch subwoofers. Make sure to set the amp gain correctly, match the impedance of the subwoofers with the amp, and use a proper enclosure for optimal performance.
Yes, a 1200 watt amp can power a 300 watt box. The wattage of the amp refers to its maximum power output, so it can deliver up to 1200 watts if needed. As long as the amp is set up properly and not pushed to its maximum capacity, it can safely power a 300 watt box.
crutchfield has a wiring diagram for all kinds of configurations, check it out.
1200 Watt wiring is more than enough for an 800 Watt amp. The rating of the sub doesn't make any difference to the cables. If you want to use the sub to its rated power you should get a bigger amp. If the amp can only give out 800 Watts and the sub can take 1100 Watts then you can put a bigger amp on. It is still going to be loud as with an 800 Watt amp. I have a 300 watt amp with a 1200 Watt sub and people hear me coming.
No, it is not recommended to use a 1200 amp adapter for a 500 amp appliance. The adapter should match or exceed the amp rating of the appliance to avoid damaging the appliance or creating a potential safety hazard. It is best to use an adapter that closely matches the amp rating of the appliance for optimal performance.
The best way to hook up a single 12 inch dvc to a 1200 watt amp is to use an MTX thunder box.
Would be compared to 1200 watt amp
It's actually a good idea to have a speaker that can handle higher wattage than the amp can produce.
HIRE AN ELECTRICAL CONTRACTOR. If you're not an electrician and you're thinking you can put in a 1200 amp service yourself, you can't. If you need to ask how, you shouldn't even be thinking you can. This is a large job which needs to be completed by an electrical contractor. Period.
you just need one, a general rule of thumb is that the wattage on your amp should be double the wattegae on your sub, hence if you have a 1200 watt sub you'll need a 2400 watt amp
A #14 copper wire rated at 15 amps is the minimum size wire for a 15 amp receptacle.
1000-1200 watt peak amp its rated at 350RMS and breaks at 1200 watts so ether a 500-600RMS should do fine and sound killer