0
Want this question answered?
Be notified when an answer is posted
Add your answer:
Earn +20 pts
What is the angle in degrees moved by the crankshaft of a four cylinder engine between firing impulses?
720°
What is the correct angle of throwing a javelin?
The correct angle of throwing a javelin is 45 degree.The physics concept behind this is known as impulse.According to this law if an object is thrown at an angle of 45 degree it travels much range(horizontal distance) than throwing at any other angle this law not only applies for javelin but also for firing an cannon or shooting a gun on an arrow into the space.
What is synonym of delay?
delay,wait,stop
What is another word for without delay?
Another word for "without delay" is immediately.
What are the types of geometric angles?
Right angle, obtuse angle, acute angle, supplementary angle, complementary angle, interior angle, exterior angle, adjacent angle
What is the relationship between the firing delay angle and the input power factor?
The firing delay angle is the point in the AC cycle at which a thyristor starts conducting. By adjusting this angle, the power factor of the system can be controlled as it affects the balance between real power and reactive power. A smaller firing delay angle can improve the power factor by reducing the phase difference between voltage and current.
How do you control firing angle of scr?
By controlling the amount of gate current !!
What is the calculation for changing the firing angle in scr-?
The calculations for changing the firing angle in SCR is K = 1 [π − α + 1 sin(2α )]
What is the firing angle of silicon controlled rectifier?
The SCR turns on based on gate voltage. The firing angle will depend on the point in the AC cycle where the gate voltage is where you want it, so the firing angle is a function of circuit design, not of the SCR.
What is the effect of changing the firing angle?
Changing the firing angle affects the conduction angle of the AC voltage waveform supplied to the load in AC-DC converters like controlled rectifiers. By altering the firing angle, the average output voltage and hence the power delivered to the load can be controlled, affecting the speed or intensity of the load, like in motor control applications.
What is transit angle in two cavity klystrons?
it is simply the phase delay occurring in the transit time. :)
What is minimum firing angle?
It means the minimum current can trigger the SCR to operate.
Do we have any change in the power consumption if you change the regulator from 1 to 5?
yes, since a triac is employed and changing regulator from 1 to 5 is infact increasing delay in the firing angle of thyristor that is less portion of input AC cycle is getting way to the load and therefore power consumption is decreasing
What is firing angle in thyristors?
A sinusoidal AC waveform is divided up into 360 degrees, with the positive half and the negative half of the waveform combined into a kind of circle. The firing angle simply refers to the point on the waveform, as measured in degrees (thus 'angle') which the thyristor is triggered into conduction. Answer2: Firing angle is the phase angle of the voltage at which the scr turns on. There are two ways of turning an scr on..one is by applying a gate current or by applying a voltage across the scr until it becomes greater than the breakover voltage.... Answer3: Thyristor need gate current and voltage to make it conduct. The firing angle is the sinusoidal increasing voltage. As it rises a voltage is reached with enough power to fire to trigger the gate. That voltage is the angle considering that a sinusoidal is 360 degrees per cycle.
What is the angle in degrees moved by the crankshaft of a four cylinder engine between firing impulses?
720°
What angle for firing projectiles gives the longest range?
It depends on the weapon. A rifle will have a very low angle--maybe ten degrees. A mortar needs a very high angle to give a good range. And a howitzer needs about a 45 degree angle to give long range.
What is a hangfire?
Hangfire - A delay between the firing pin blow and the ignition of the powder, usually caused by old or contaminated primer/propellant which ignites slower than usual.
