(-5,3)
Conventionally positive angles are measured anticlockwise. It depends where the centre of rotation is, so where would you like the image to be? If the centre is at, say, (3, 5) then the image will be at (3, 5) regardless of the angle of rotation. If the centre is at, say, (3, 3) then the image will be at (5, 3) If the centre is at, say, the origin, ie (0, 0) then the image will be at (5, -3).
Conventionally positive angles are measured anticlockwise, by 180° is a half turn regardless of direction. It depends where the centre of rotation is, so where would you like the image to be? If the centre is at, say, (4, 3) then the image will be at (4, 3) regardless of the angle of rotation. If the centre is at, say, (4, 4) then the image will be at (4, 5) If the centre is at, say, the origin, ie (0, 0) then the image will be at (-4, -3).
1 rotation = 360 degrees 3/4 rotation = 270 degrees
270=2*3*3*3*5
(-5,3)
What is the image of point (3, 5) if the rotation is
The image is (-5, 3)
All rotations, other than those of 180 degrees should be further qualified as being clockwise or counter-clockwise. This one is not and I am assuming that the direction of rotation is the same as measurement of polar angles. Also, a rotation is not properly defined unless the centre of rotation is specified. I am assuming that the centre of rotation is the origin. Without these two assumptions any point in the plane can be the image. With the assumptions, for which there is no valid reason, the image is (3, -4).
It is: (-4, -3)
It then is: (-3, -5)
It is: (-4, -3)
The answer will depend on where the centre of rotation is. Since that it not specified, the image could by anywhere.
There are 270 degrees in 3/4 of a rotation
The answer depends on the centre of rotation. A rotation cannot be described without specifying the centre of rotation.
The answer depends on the centre of rotation. A rotation cannot be described without specifying the centre of rotation.
The answer depends on the centre of rotation. A rotation cannot be described without specifying the centre of rotation.