0
The space between the end of the meter stick and the 1 centimeter mark isn't necessarily 1 centimeter because of differences in the production process
pm is short for pico-meter, or 10-12 meter. That's a trillionth of a meter (using the short scale), or a billionth of a meter on the long scale.pm is short for pico-meter, or 10-12 meter. That's a trillionth of a meter (using the short scale), or a billionth of a meter on the long scale.pm is short for pico-meter, or 10-12 meter. That's a trillionth of a meter (using the short scale), or a billionth of a meter on the long scale.pm is short for pico-meter, or 10-12 meter. That's a trillionth of a meter (using the short scale), or a billionth of a meter on the long scale.
160 Celsius = 320 Fahrenheit
It is used to measure centimeters; a centimeter is a unit of length, equal to 1/100 of a meter. It is used all over the world.
12
1 cm = 1/100 meter
Always start with the highest scale, than work your way down until you get a midscale reading. If you start with a low scale, you will overrange the meter, which can damage it in severe cases (especially the older analog meter movements).
How can you measure water purity ?
we can measure the distance by meter scale
newton meter
Mega = million Megaohm = 1000000 Ohms
It can, but the vernier is capable of a more accurate reading.
With the pointer mid range on the scale, the reading of the multi-range voltmeter would be 125 volts.With the pointer mid range on the scale, the reading of the multi-range voltmeter is 125 volts.
a multimeter probably has a Ohm meter as well. If yes, use it and make sure you have the correct scale adjusted. If there is no Ohm meter you should calculate the resistance using Ohms Law. So if you use your multimeter as an Amp meter (in series with the unknown resistor) and you apply a know voltage across you should be able to calculate the resistance by dividing the voltage you applied by the current you meassured (R=v/I) ANSWER: 1 make sure ther is no external power connected 2 short the leads together and adjust for zero reading on the meter. This step is necessary to eliminate the internal battery drifting with time. Unlike voltage and amps reading the scaling of the meter is not important to begin with since a peg meter or a overflow will not destroy the meter immediately but do change the scale to get maximum deflection or digital display.That it
When reading the needle on an analog meter, you can get a slightly different reading depending on the position of your eye relative to the needle and the scale behind the needle. This is parallax. The digital meter reads the exact value measured (to the accuracy of the meter), and then displays it in the form of "numbers" or "digits" so your eye is not interpreting the value from a scale.
this sounds like homework?
Depending upon the voltmeter, the 300 volt range would typically be the most correct to give you a mid-scale reading of 120volts.
Take a sound pressure level meter (SPL meter). Try to measure the sound pressure p in pascals or in decibels, referred to the threshold of hearing with 20 micropascals.