Length X Width. For example, a rectangle with a short side of 3 inches and a long side of 5 inches would be 15 inches square. Just like a square.
I diagram shaped like a rectangle, with a word in the center of therectangle, where you make four quadrilaterals which are going into a greater position on the outside of the rectangle. Like a square Simon Sez.
Assuming 96 refers to the area of therectangle, the answer is: infinite. Consider the following sequence of rectangles with breadh B units and length L units.: Breadth = 1 Length = 96. Area = 96, Perimeter = 194 B= 0.1, L = 960. A = 96, P = 1920.2 B = 0.01, L =9600. A = 96, P = 19200.02 B = 0.001, L = 96000. A = 96, P = 192000.002 There is no limit to how small B can get and therefore, how large P can get.
Carpet area is carpet area and retail area is retail area
the energy in the area is called ME-Kos.
There is a theorem which proves that the interior angles of a triangle add to 180o. It is too difficult to show the proof here, but you can easily make a demonstration: cut a triangle out of paper; make a pencil mark in each corner of the triangle. Cut or tear off each corner, and fit thethreemarked angles together. They should make a straight edge, which is a 180o angle.Draw a line joining two opposite corners of a rectangle; you have divided it into two triangles. Each of these triangles has angles that add to 180o; together, the six angles of the twotrianglesform the angles of therectangle and must add to 2x180o = 360o.
The sternal area (the area near the breastbone) is superior to the umbilical area (the area near the bellybutton or navel.)
-- Find out the population of the area. -- Find out the area of the area. -- Divide the population by the area. The result is the population density of the area.
Area having a common drainage is catchment area, whereas area which is uses that water from common drainage area is command area.
Built up area is the area which has been developed.and floor area is the area which is about to built or about to develope.
length x width = area
all you do is find the area of the circle... if you mean find the squares area, find the area of the circle, and then the square's area and subtract the squares area to the circles area
You can convert the built up area into the carpet area by simply covering the area in a carpet.