AWG # 14 is the smallest wire you can install in a home and it can only be used in living areas. It will carry 15 amps.
Wiki User
∙ 10y agoA #8 copper wire with an insulation factor of 75 or 90 degrees C is rated at 45 amps.
A #6 copper conductor with an insulation factor of 75 and 90 degrees C is rated at 65 and 75 amps respectively.
The minimum wire size allowable would be 10 gauge. For a 75 foot run however, the voltage drop would be 5.31 volts. This exceeds the NEC recommendation of no more than 3% (3.6v) so while it is not legally required, for best efficiency, you should run 8 gauge.
Aluminum 4/0 wire car carry 180 amps at at 75 degrees Fahrenheit or 205 amps at 90 degrees. .
A #12 aluminium conductor with an insulation factor of 75 or 90 degrees C is rated at 15 amp. Therefore the largest size breaker to protect that wire will be a breaker rated at 15 amps.
A #6 copper wire with an insulation factor of 75 and 90 degrees C is rated at 65 amps.
The maximum amperage of a 0 gauge wire typically ranges from 150 to 200 amps for automotive applications. However, it is important to consult the specific manufacturer's guidelines and consider factors such as temperature and installation conditions to ensure the safe use of the wire.
#8 copper
A #8 wire with an insulation rating of 75 or 90 degrees C is rated at 45 amps.
The amperage rating of 12 gauge wire is typically around 20 amps for residential electrical wiring. However, it's important to consult the National Electrical Code (NEC) and local building codes for specific applications to ensure safety and compliance.
No, an 8 gauge wire is typically rated for a maximum of 40 amps. It is important to match the wire gauge with the appropriate amperage to prevent overheating and potential fire hazards. In this case, you would need to use a thicker wire gauge, such as 6 gauge, for a 50 amp breaker.
For a 25 amp load at 220 volts over a distance of 75 feet, you will need a 10-gauge wire to ensure safe and efficient electrical conductivity. This wire size allows for minimal voltage drop and meets the necessary ampacity requirements for the circuit. Make sure to consult local electrical codes and regulations before installation.
Number 6 gauge wire typically has an ampacity rating of around 55-75 amps and a voltage rating of 600 volts. These ratings may vary depending on the specific type of wire and the regulations in your area. It is important to consult the National Electrical Code (NEC) or a qualified electrician for accurate information.
This is a voltage drop question. To answer this question a voltage must be stated.
A #8 copper wire with an insulation factor of 75 or 90 degrees C is rated at 45 amps.
A # 6 copper wire with an insulation factor of 75 or 90 degrees C is rated at 65 amps. Code states that conductors can only be continuously loaded to 80%. 65 x .8 = 52 amps.
A #6 copper conductor with an insulation factor of 75 and 90 degrees C is rated at 65 and 75 amps respectively.