the horizantal stablers are used to control the planes . i think o.0
- Rhazhaa Nickolee
Since a hexagon is a horizontal plane figure it cannot have a horizontal plane of symmetry.
vertical - - - - - - - - - - horizontal -------------------------------
A line which divides a body into two parts, such that each part is the mirror image of the others, then the line is called a line of symmetry. If such a line is parallel to the horizontal plane, then it is called a horizontal line of symmetry. Else, if the line of symmetry is perpendicular to the horizontal plane then it is a vertical line of symmetry.
.50g
A vertical or horizontal stabilizer helps the plane to be balanced
the horizontal stabilizer controls the pitch of the airplane
The tail assembly of an aircraft, including the horizontal and vertical stabilizers, elevators, and rudder.
It also won't work if it has no vertical stabilizers. It only has a horizontal stabilizer. And race cars are meant to be close to the ground so it wouldn't work to have it in the sky.
The tail of the typical airplane is made up of two horizontal wings which are called the horizontal stabilizers. the have flaps in the back of them that will stabilize the attitude of the plane at varying speeds. without it it would never get of the ground or stay in the air. The wing that points upwards is the vertical stabilizer and can be compared to the keel on a boat it will control the direction that the plain is pointed in.
Lift is what ultimatly causes the plane to take off. When a plane get up to take off speed, that means the wings are generating enough lift to lift the plane up. The pilot will change the planes angle of attack with the elevators (located on the horizontal stabilizers) to the wind which forces engine thrust to push the plane into the air.
An inclined plane is a plain surface set at an angle other than a right angle against a horizontal surface
Since a hexagon is a horizontal plane figure it cannot have a horizontal plane of symmetry.
A horizontal angle is an angle between lines on a horizontal plane.
By the definition, A plane which makes an angle (THETA) with the horizontal is said to be inclined plane. Inclined plane has made lots of work very easy. It's a simple machine.
it is the Transverse plane. the transverse, or horizontal plane is a crosswise plane that runs parallel to the ground. this imaginary cut would divide the body or its parts into upper and lower portions.
transverse
because they are parallel to the plane of the horizon