0
Add your answer:
Earn +20 pts
What is the diameter of a shoelace hole?
Typical diameter of a plain punched shoelace hole (no reinforcing eyelet) is 3.5 mm. Eyelets can vary quite a bit in size, but most range from 3.5 mm to 4.5 mm.
What is diameter of 5 ft circle?
5 ft
What is the diameter of 5 gallon water container?
th diameter of this is 7000 litres
What is the cross sectional area of a 2 inch diameter bar?
3.1416"Answer:3.1416 square inches.
If the diameter is 5 what is the circumference?
20
What is extreme steel bar?
Extreme Steel bar is known as re-bar ( Reinforcing Bar), with two longitudinal and transverse ribs on the diameter of Bar.
What is the weight of 25 mm diameter reinforcing bar per meter?
Weight = {(3.1416 (0.025)^2) / 4 }* 7850 kg/m^3 * 1m = 3.85336 kg/.
What is the unit weight of rebar 36mm?
The unit weight of rebar (steel reinforcing bar) with a diameter of 36mm is approximately 3.18 kg/m.
What is the difference between 5 and 6 rebar?
The diameter of the bar. #6 is 1/8" larger than the #5.
What does F82 reinforcing stand for?
8mm diameter bars at 200mm x 200mm square spacing
What is TMT Re-Bars?
Thermo mechanical tempered Reinforcing bar or Structural steel
What diameter is a Y12 bar?
12mm
What is weld lap length of reinforced concrete bars?
when length of reinforcing bar is small and we have to provide longer reinforcement in that case the second bar is provided with proper overlapping with the first bar this overlapping is known as lap length. the straight length of shall not be less than 12mm dia and 200mm length.
rinforzando?
reinforcing
What are the unit weights of 22mm reinforcing steel bars?
22mm diameter deformed bars unit weight kilogram per meter
How do you calculate inch diameter for reinforcement pad in pipe?
Reinforcing pads mirror the pipe that they are being welded to in size, thickness, and material. To measure the diameter of the pad, measure the pipe at a cross section.
What is the development length in concrete?
Development Length is the shortest length needed for reinforcing bar so that the stresses can induced in the bar can increase from zero to the yield strength of the said bar. The development length is a function of the bar size, yield strength, concrete strength and other factors such as coating of the bar. Also, the development length of a bar is dependent to whether the bar is in tension or compression. Tension development lengths are larges than compression development lengths because in compression, the reinforcing bar gets some help from the concrete, while in tension it does not.
